Vse kategorije » 1. Troubleshooting
The category consists solutions for problems with UPSs
Pogosto zastavljena vprašanja (FAQ)
-
1. Troubleshooting procedure
-
An EPO Alarm (Emergency Power Off)
-
A backup time is too short
-
A fan is too loud
-
A measured voltage is ~160V, but software shows 230V (True RMS measurement)
-
A UPS displays "0" on the LCD.
-
A UPS reports overload, but the connected load is below its maximum
-
A UPS stopped working after a storm
-
A UPS switches off after 30/60min on battery
-
A UPS switches off immediately after input fails
-
A UPS switches off in a battery mode, but the load was small and battery full
-
A VI UPS is working loud for some period of time
-
Claiming battery failure
-
Code Messages for VI RLE, VI R1U and VI STL
-
Output voltage is too high/low and much different than the input voltage
-
Site Wiring Failure
-
UPS losing connection with the monitoring software