Frequently Asked Question

Configuring a PC powered by Multi-UPS shut down

Zadnji ažurirao 5 godina prije

For local computer: If there are more than one UPS supplying power to the local computer with software as below 4.2.1, you want to safely shut down or suspend the local computer before all UPS can’t supply power to the local computer. You should select the “Multi-UPS input” option in the “shutdown settings” dialog of each UPS and set condition, refer to the following figure 4.2.2. The local computer won’t be shut down or in suspend mode until all the condition of all UPS is met.

image

Figure 4.2.1
image

Figure 4.2.2

For remote computer without communication with UPS: If there are more than one UPS supplying power to the remote computer with software, you want to safely shut down or suspend the remote computer before all UPS can’t supply power to the remote computer. You should configure the software installed on the remote computer to be shut down by another computer, refer to the following figure 4.2.3, and in the “shutdown settings” dialog of another computer with software communicating with the two UPS to shut down the remote computer, the shutdown condition of each UPS should be set separately, refer to the following figure 4.2.4 and 4.2.5. The remote computer won’t be shut down or in suspend mode until all the condition of all UPS is met.

image

Figure 4.2.3
image

Figure 4.2.4

image

Figure 4.2.5

Molimo Vas pričekajte!

Molimo Vas da pričekate... ovo će još trajati par sekundi!