Ofte stilt spørsmål

Siste oppdaterte 6 år siden

Series PowerWalker VI RT HID and PowerWalker VFI RT HID are based on the same housing components and require additional information for a proper setup.

Content of the UPS's box

The UPS

Accessories:
1. Tower Holders (4 parts, 2 sets) (for tower setup only)
2. IEC output cables (IEC C13 to IEC C14)
3. IEC input cable
4. USB cable
5. Rack Ears (for rack setup only)
6. Screws for Rack Ears
7. EPO plug

Content of the Battery Pack's box
(in case a battery pack is used)


The Battery Pack

Accessories:
1. Grounding cable
2. Tower Holder extensions
3. Screws
4. Stabilizing bracket (for tower setup)
5. Rack ears (for rack setup)

Connecting the internal batteries
Every UPS is delivered with internal batteries disconnected. It is also necessery to disconnect them again in case of transportation. The connectors are located behind the front panel.

Setting up the UPS in rack cabinet
Warning: to install the UPS in 19-inch rack cabinet you need special Rack Mount Kit. We recommend original model RK1.

Connecting Rack Battery Packs
The video is simplified, assuming you have already watched the video above.
You may follow this instruction to connect more BPs in parallel.

Setting up the UPS in tower form

Connecting Tower Battery Packs
The video is simplified, assuming you have already watched the video above.
You may follow this instruction to connect more BPs in parallel.

Replacing an old Battery Set
This video is not a part of standard setup, but it instructs how to replace old battery set. This operation can be also performed while the UPS is in operation (the batteries are how-swappable). If you need a new battery set, please contact one of our distributors. If you are not sure which Battery Set is correct, please contact our service support.

Printed instructions
You can also download a short pdf if you need a printed version for field installation. (please see the attachment on the right)